@MuntyScruntFundle wrote:
Hi folks. Here I am again with another model problem I don't understand.
In Blender I created a simple object just for testing. It's an icosphere surrounded by 5 other smaller icospheres, it looks like a few joined bubbles. I Joined all the objects, CTRL+J so there is only one mesh and exported them. So far so good.
When I get the model into my code it draws ok, but no matter what the orientation of the model the smaller spheres display behind the larger. So as I'm spinning the object the orbiting spheres always draw behind the larger.
The larger sphere was created first in Blender, but there are no parents or children or anything slightly complicated.
Any ideas?
Thanks.
Posts: 7
Participants: 3